Select Language

Horizontal Shaft (HS) Impact Crusher are used for crushing hard rocks. Three sets of separately adjustable anvils are embedded in HS Impact Crusher, providing control in production.

The top anvil is made from manganese steel and the middle and bottom anvils are made from iron and covered with manganese shoes. HS Impact Crusher utilizes a heavy duty disk rotor that provides a large moment and uniform rotation, hence perfect feeding and material saving.

Hammers, anvils and protective parts are all made from manganese steel which provides high durability.


Impact Crusher are available in HS14, HS10 and HS7 types with an embedded tuning screw that adjusts the output between 0 to 6 mm. This type of Impact Crusher can also be used as sand maker at the beginning of crusher lines.

 


Advantages of Impact Crushers:

  • Heavier rotor compared to other devices which lowers energy consumption and also electrical current fluctuations in the device.
  • The Rotor incorporates five 80mm-thick plates made from ST52 sheet.
  • The rotor axle is made from a 30mm-thick Mannesmann tube.
  • The surfaces of all fittings of the rotor hammer are machined which facilitates welding in addition to balancing the rotor, thus preventing cracks and failure and increasing rotor durability.
  • The main shaft of the machine is made from MO40 forging steel.
  • Belarusian MPZ ball bearings are implemented in the device.
  • The device is equipped with rubber dampers in order to prevent vibration form being transferred to the chassis and foundation, and to protect ball bearings, thus extending their life.
  • All foleys are equipped with taper bushing which facilitates repairs and prevents corrosion and loosening of the foley pin.
  • The frame of the device is fully coated with 45mm of manganese steel.
  • The feed inlet opening is fully covered with 45mm manganese steel liners.
  • The feed inlet opening is equipped with a replaceable rubber curtain that prevents rocks from being thrown out of the machine.
  • The hydraulic system is connected to the machine via taper coupling which enables the user to easily disconnect the hydraulic system. This means that during changes, the hydraulic system can be brought to the device and back to the warehouse, when the job is finished, by one person; which extends the life of the hydraulic system.
  • The upper frame of the device slides open leaving more space to the repair crew.
  • This device is equipped with girder and trolley to facilitate repair and replacement of the hammers.

Add comment


Security code Refresh

img topsoc

 insta  in  twitter  telegram  google

Contact Us

location

Ghaem Mashin St. - Haft Jooy - Shahriar to Karaj Road - Tehran - IRAN

(+98 21 ) 46892019 & 46892025

(+98 21 ) 46893630 & 46893639

(+98 21 ) 40446010 - 15           

 info@kosarsc.com